Be the first to write a review
You must be logged in to post a comment.
₹500.00 – ₹550.00
– Double rings anchors available in SS 316 (for M12 bolts) and SS 304 (for M10 bolts) grades
– Our regular Dynamo rock anchor conforms to EN 959:2016 and CE 3076
– MBS (rings): 30 kN
You must be logged in to post a comment.
– Heavy duty textile with coating on both sides. This means a substantially long life of the protector
– Velcro fastener along the length of the protector
– Fabric has insulating properties to prevent the rope from getting heated up too easily
– Stainless Steel 304 Rock hangers for outdoor use (not marine grade).
– Bore diameter: 12mm
– This hanger features chamfered edges of the eye hole to minimize wear on carabiner. The eye hole itself is large enough to accommodate two carabiners.
– Choose the bolt size carefully depending upon strength of base rock material. If the rock is soft or has uneven composition such as Sandstone and Limestone, then any rock anchor, including ours will not be strong enough to endure heavy loading.
– This anchor is not recommended for use in coastal areas because it may not last as long as it normally should. For areas within 100 kms of coastline we recommend the anchors must be made in marine grade Stainless Steel. Contact us if you want these to be custom made!
– If you are combining our hangers with your own bolts, ensure that they are made from the same grade of metal.
– Each hanger is tested at a proof load of 8kN before shipping. You will be able to see a very small indentation on the side of the eye-hole. That is because it was tested in our lab for your safety.
The recommendation below is based on several assumptions. Do your own due diligence before installing an anchor anywhere.
M10 bolt: Only to be used in very hard rocks such as Granite (Compressive Strength > 75MPa)
M12 Bolt: Only to be used in medium to high hardness rocks such as Sandstone (Compressive Strength > 30MPa)
– EN959:2007, CE3076
User Instructions Download the PDF
User Instructions Download the PDF
This is an all-rounder climbing harness designed specifically for lead climbers. The well thought out features and its ergonomic design makes this one harness very versatile and suitable for many forms of climbing. This harness features our Lean waist belt. It above normal width but countered and lean design makes for a perfect fit around your waist. This feature was added keeping the route openers in mind who might have to hang in their harnesses for longer durations while bolting a new route.
TECHNICAL SPECIFICATIONS
• Waist belt strength rating: 18kN. For your comparison UIAA’s minimum requirement: 10kN)
• Belay Loop breaking strength: 26kN. UIAA’s minimum requirement is 15kN
• Buckles: Stainless Steel. Breaking strength = 16kN
• the harness is made from BLUESIGN certified breathable and water repellent Sympatex fabric. The fabric is a three layered bonded fabric that is made in Japan.
• Haul Loop on the rear rated at 5kN
• Molded gear loops: 4
• Leg Loops: Elasticated
• This is a Unisex harness
• Weight: 300gms
• EN 12277, CE
Recommended Use
Lead climbing, trad climbing, sport climbing, mountaineering
– 304 Stainless Steel for outdoors and indoors use
– Breaking Strength : 45kN, Safe Working Load: 11kN
– These are not yet CE and UIAA certified but we guarantee the performance and breaking load
– Individually tested before shipping for your safety
Reviews
There are no reviews yet!